附面层抽吸对叶栅角区分离流动的控制研究

doi:10.13675/j.cnki. tjjs. 180628

推进技术 ›› 2019, Vol. 40 ›› Issue (9): 1972-1981.DOI: 10.13675/j.cnki. tjjs. 180628

附面层抽吸对叶栅角区分离流动的控制研究

梁田¹,刘波¹,茅晓晨¹

西北工业大学动力与能源学院

发布日期:2021-08-15
作者简介:梁田，硕士生，研究领域为叶轮机械气动热力学。E-mail：seakro@163.com
基金资助:
国家自然科学基金面上项目 51676162;先进航空发动机协同创新中心国家自然科学基金面上项目（51676162）；先进航空发动机协同创新中心资助。

Investigation of Corner Separation Control forCascade with Boundary Layer Suction

School of Power and Energy,Northwestern Polytechnical University,Xi’an 710129,China

Published:2021-08-15

摘要/Abstract

摘要： 为研究附面层抽吸对叶栅角区分离流动的控制效果和机理，以高负荷轴流压气机叶栅为研究对象，基于数值方法深入分析了不同抽吸方案对叶栅角区流场的影响以及叶栅攻角特性随抽吸流量组合的变化规律。结果表明：不同抽吸方案对叶片通道中的分离流动的控制机理不同，进而会影响叶片负荷及扩压能力；将吸力面抽吸与端壁附面层抽吸结合起来的组合抽吸方案基本消除了位于叶栅吸力面的附面层分离和角区分离，叶栅叶型损失系数显著降低，在5°攻角下，当吸力面抽吸量为1.88%，端壁抽吸量为0.82%时，损失系数相较于原叶栅降低约63.8%；并且进一步研究发现各抽吸槽的抽吸流量均存在其最佳临界值；在进行组合抽吸时，应针对不同攻角工况，在其相应的临界值范围内选择合理的抽吸流量，以达到用较小的吸气量实现对叶栅分离流动的控制。

关键词: 压气机叶栅;三维角区分离;附面层抽吸;攻角特性

Abstract: In order to study the effectiveness and mechanisms of boundary layer suction in controlling the corner separation, numerical simulations are carried out for a highly-loaded axial compressor cascade to investigate the effects of different suction schemes on the flow field around the corner and the change law of the incidence characteristics of cascade with the variation of the suction rate combination.The results show that different aspiration schemes have different effectiveness in controlling the flow separation, which leads to various influence on the blade loading and the diffusion abilities. The combined suction scheme fully remove both the sepatared flow on the blade suction surface and the three-dimensional hub corner separation. The profile loss coefficient is reduced significantly by 63.8% with the suction flow rate of 1.88% and 0.82% given for the slot on the blade suction surface and the slot on the end-wall respectively in the scheme of combined suction when incidence angle is 5°. And further work showed that the suction rate is not as great as possible. A reasonable suction flow rate should be selected within the corresponding critical value range for different incidence conditions in order to control the separation flow with a small suction.

Key words: Compressor cascade;Three-dimensional corner separation;Boundary layer suction;Incidence characteristics

梁田,刘波,茅晓晨. 附面层抽吸对叶栅角区分离流动的控制研究[J]. 推进技术, 2019, 40(9): 1972-1981.

LIANG Tian¹,LIU Bo¹,MAO Xiao-chen¹. Investigation of Corner Separation Control forCascade with Boundary Layer Suction[J]. Journal of Propulsion Technology, 2019, 40(9): 1972-1981.

参考文献

[1] Lei V M, Spakovszky Z S， Greitzer E M. A Criterion for Axial Compressor Hub-Corner Stall[J]. Journal of Turbomachinery， 2008， 130(3).
[2] Zhang Y， Mahallati A， Benner M. Experimental and Numerical Investigation of Corner Stall in a Highly-Loaded Compressor Cascade[R]. ASME 2014-GT-27204.
[3] Beselt C， Eck M， Peitsch D. Three-Dimensional Flow Field in a Highly Loaded Compressor Cascade[R]. ASME 2014-GT-25947.
[4] Peacock R E. Boundary Layer Suction to Eliminate Corner Separation in Cascades of Airfoils[R]. NACA-RM-3663， 2013.
[5] Hubrich K， Bolcs A， Ott P. Boundary Layer Suction Via a Slot in a Transonic Compressor Numerical Parameter Study and First Experiments[R]. ASME 2004-GT-53758.
[6] Gbadebo S A， Cumpsty N A， Hynes T P. Interaction of Tip Clearance Flow and Three-Dimensional Separations in Axial Compressors[J]. Journal of Turbomachinery， 2007， 129(4).
[7] Gbadebo S A， Cumpsty N A， Hynes T P. Control of Three Dimensional Separations in Axial Compressors by Tailored Boundary Layer Suction[J]. Journal of Turbomachinery， 2008， 130(1).
[8] Leishman B A， Cumpsty N A， Denton J D. Effects of Bleed Rate and Endwall Location on the Aerodynamic Behavior of a Circular Hole Bleed off Take［J］. Journal of Turbomachinery， 2007， 129(4): 659-668.
[9] Leishman B A， Cumpsty N A. Mechanism of the Interaction of a Ramped Bleed Slot with the Primary Flow［J］. Journal of Turbomachinery， 2007， 129(10): 669-678.
[10] 张华良，谭春青，张新敬，等. 采用附面层抽吸(BLS)控制流动分离的数值模拟[J]. 推进技术， 2009， 30(2): 192-196.
[11] 张华良. 采用叶片弯/掠及附面层抽吸控制扩压叶栅内涡结构的研究[D]. 哈尔滨：哈尔滨工业大学， 2007.
[12] 张华良，王松涛，王仲奇. 端壁附面层抽吸对扩压叶栅内分离结构的影响[J]. 热能动力工程， 2006， 21(6): 565-568.
[13] 王松涛，潜纪儒，冯国泰，等. 壁面吸气抑制分离减少流动损失的研究[J]. 工程热物理学报， 2006， 27(1): 48-50.
[14] 陈绍文，郭爽，宋宇飞，等. 局部附面层抽吸对高负荷扩压叶栅流动特性影响[J]. 工程热物理学报， 2010， 31(3).
[15] 宋彦萍，陈浮，赵桂杰，等. 附面层吸除对大转角压气机叶栅气动性能影响的数值研究[J]. 航空动力学报， 2005， 20(4): 561-566.
[16] 刘波，李志鹏，赵鹏程，等. 高负荷吸附式压气机叶栅数值与实验研究[J]. 航空动力学报， 2014， 29(1): 133-139.
[17] 刘波，曹志远，魏巍，等. 级环境下附面层抽吸对对转压气机性能的影响[J]. 航空动力学报， 2013， 28(4): 885-892.

附面层抽吸对叶栅角区分离流动的控制研究

Investigation of Corner Separation Control forCascade with Boundary Layer Suction

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价